Page 2 of 2
Posted: Wed Jul 18, 2007 9:59 pm
by Pete Zaria
I use a 12V rechargeable cordless drill battery, but a 9 volt and two AA's in series works fine (just doesn't last as long).
If you can't solder, alligator clips and electrical tape are your best bet. A cheap soldering iron is about $10.
Peace,
Pete Zaria.
Posted: Wed Jul 18, 2007 10:07 pm
by Thrilla
Even a lighter and electrical tape / heat shrink tube will do.
Strip the wires, twist some fine solder onto the bare wire, heat with a lighter, then insulate.
Posted: Thu Jul 19, 2007 3:36 am
by mtronic
Starting voltage for many computer fans is 7v, below that it won't even start
My fan used to run off a 6v battery and pretty fast too. Maybe some fans just suck ass?
Posted: Thu Jul 19, 2007 5:32 am
by flamerz14
ok..dead post but thanks anyways..
Posted: Thu Jul 19, 2007 6:35 am
by Thrilla
mtronic wrote:Starting voltage for many computer fans is 7v, below that it won't even start
My fan used to run off a 6v battery and pretty fast too. Maybe some fans just suck ass?
Many, not all lol. I have a brushless fan with a max power rating of 5v, starts at 1.5v. hmm this actually reminded me, I could use that 5v blower fan to mix fual, it blows air in 360 degrees instead of only one direction.