Page 2 of 2
Posted: Sat Jul 28, 2007 4:14 pm
by Alabaster
What did you use for the center of the piston?
Posted: Sat Jul 28, 2007 4:40 pm
by origin unknown
I used a bolt and a nut to put the sealing face on. The pic was kinda blurry so it was hard to tell what it was.
Posted: Sat Jul 28, 2007 5:05 pm
by Alabaster
Cool didn't cost allot did it?
Posted: Sat Jul 28, 2007 5:12 pm
by origin unknown
I found the nuts and bolts in my dad's workshop and I bought the 1/8" rubber at lowes for $2 in the plumbing section.