Page 3 of 3

Posted: Fri Sep 07, 2007 11:14 am
by ALIHISGREAT
frankrede wrote:Cotton string works great for cutting pvc, unless the piece is too thin or it will break, and it makes perfect cuts that are straight.
cool i didnt realise that you could use string

Posted: Thu Sep 13, 2007 6:27 pm
by dongfang
Hi,

I use a miter-box saw (an all metal thing running on guide rods, not a wooden box thing), but if I had a pipe cutter, sure I would use it. Or anything else that makes a nice rectangular cut.

Regards
Soren

Posted: Thu Sep 20, 2007 4:13 pm
by HaiThar
Pete Zaria wrote:These are around $10-12 at the local hardware store (for one that cuts 2.5" pipe and smaller, the bigger one [which cuts upto 4"] is around $25):

Image

Image

You put the pipe in the jaws, clamp down the blade until it just makes contact with the pvc, rotate the pvc in the jaws a few times, crank down the blade a little bit tighter, repeat (the cut gets deeper each time), 10 passes or so produces a perfectly clean cut. They also cut soft copper just fine, but eventually you need to replace the blade (about $2...).

Am I the only one that has one of these? :-p

Peace,
Pete Zaria.
The problem with those is that they leave a sort of tapered edge on the end of PVC , which you must file or shave, or get off somehow, which is much more trouble than its worth.They do work well on copper though...

Posted: Sun Nov 01, 2009 7:53 am
by metalmeltr
Edited by jrrdw for kicking up old topic with no new relevant information!

Posted: Mon Nov 09, 2009 4:19 pm
by MasterBlaster
You could probably use an old Brake cable off a bicicyle.
I also have a wire saw which is just as effective as a hacksaw but a lot cheaper

Posted: Mon Nov 09, 2009 9:28 pm
by jrrdw
@metalmeltr

See what happens when you kick up old topics with nothing new. You get your post edited in a embarrassing way. This is the second time you've been told. What does it take? Everybody pointing their finger at you in public.