Page 3 of 3
Posted: Fri May 02, 2008 7:53 pm
by sjog
I used the Asco as my main valve and got 500fps so your piston must have some good numbers
Posted: Fri May 02, 2008 8:04 pm
by unisonmind
ya but my piston is heavy the pill bottle is 3'' x 3'' and filled with epoxy-- thats why i used such a overkill pilot valve its a nice balance
Posted: Sat May 03, 2008 3:26 am
by dongfang
Hi,
OK looking at it again, those 8 * 8mm bolts of mine are in a 75mm ID bushing around the tee (I forgot).
In any case, just go shooting with it, and if you - after having it apart for a few times - notice that the bolts have exerted a lot of pressure on the plastic, maybe get some larger ones. They looked so small to me on the pictures.
Regards
Soren
Posted: Thu Jun 12, 2008 5:49 pm
by jonnyboy
Hey I'm going to build a cannon like this. I just have a question about the parts list for the "tee" and why the bolts are. Could you give me a walk through on that area.
Posted: Thu Jun 12, 2008 7:05 pm
by n-strike
Dude, this topic is almost one month old. Don't post in old topics unless you have something useful to say. Just send the person who made this topic a PM.