SpudFiles

you can't thing out how wordles i am that those solder joints held up :S

well any 10x that gets fired in chambers like this makes me want to fire my big hybrid even more

Haha my solder joints beat you anyway, the gun have very much recoil at 10x and the 10x make a very big hole in 6mm steel plate

Thank you very much!
(PS.I am too impressed that the cannon can hold 10x)

well it is copper and the soldering LOOKED bad but you might just spilled a little

i think that pipe has a burst pressure of around 2200psi - just so you know

I can take a new shot and pic from 6mm plate if you want

if i want? are you crazy?

of course i want!

Haha, I knew it...I will do it tommorow.

Here is damage pic, 6mm iron plate, the hole looks much deeper in real:


And schematic of my gun:


Hope you understand

that is so awesome!
your burst disk design gives me some ideas.. is it possible for you to get on msn and help me a little there? seems like you have your top floor in right gear

Of course I can...

coool
this gun is incredible I might try some small scale hybrid experiments:P

I like the intergrated burst disc holder, instead of having a sperate union, i was thinking of using cam-locks on mine but maybe this is a better route to go down

Thanks...I think that this is much easier because you just have to weld a big nut to your chamber and then just get a big bolt and weld your barrel to it

Ei paha. Pitänee siirtyä hybrideihin jossain välissä.

Clean and compact build. And impressive performance. I like it!