Page 3 of 3
Posted: Sat Mar 24, 2007 9:27 am
by spudthug
oo idk crowley srry
Posted: Sat Mar 24, 2007 12:27 pm
by sandman
well, im going to add up the total cost of the cannon with the pressure pipe and if its over $250 i probly will not do it
Posted: Sun Mar 25, 2007 3:31 pm
by sandman
sry, for the double post but do you think
http://www.pipestock.com/ABS_Pipe_Fitti ... Plain_138/ is really a reducer, the pic is deceiving
Posted: Sun Mar 25, 2007 3:50 pm
by allthingsgo2
I used abs on my golfball gun as well as a standard combustion spud gun.
I've had excellent results. this is all parts i got from home desperate though.
the cellular core makes me uncomfortable as to what it will hold pressure wise. but i use light fuel loads and a bbq ignitor with two screws. so its not terribly powerful but enough to keep me laughing.
Good luck.
PS: my golf ball gun cost me approx 30 bucks.
Good Luck and happy shooting
Colin
Posted: Sun Mar 25, 2007 3:58 pm
by sandman
well, i think the place that i as going to get the pipe from only ships to the UK so i think im screwed :cussing:
im power hungary so i think the cell core will not hold, but thanks for the imput Colin
Posted: Thu Mar 29, 2007 8:58 pm
by DK
sandman wrote:ok, ill try again
but i dont doubt that it will get there eventuaully
Trust me, it won't.
Posted: Thu Apr 12, 2007 5:31 pm
by sandman
ok, im sorry to dig up my old topic but i have new developments
um, i found a place that has the pipe that is close to me, but they have two kinds regular pressure rated, and class T which they say is for threading. I was wondering if i could use the class T with the regular stuff in a reducing bushing. So i could use regular for the chamber, and class T for the barrel. Just in case i ever decide to thread the end of the barrel.
http://catalogs.shoplocal.com/harringto ... genumber=5
thats the place im talking about
page 46-47 for ABS stuff
Posted: Thu Apr 12, 2007 10:46 pm
by DK
That would depend entirely on the outside diameter of the pipe. I would suspect that you could use the class T with the regular pipe in a reducing bushing. However, the inside diameter of the Class T will most likely be smaller than the regular material. I checked out the catalogue, and I don't see any problems with using that pipe. 2" is rated for 230 psi even!
As for dimensions, I would check with the company to verify that you could in fact use class T with the regular pipe and whether or not the inside diameter is less.
Cheers.