Posted: Sat Apr 21, 2007 11:09 am
And then for the front I would take another bell reducer and cut of the bigger end right where it meets the angled part to create a blast deflector.
Page 3 of 3
Posted: Sat Apr 21, 2007 12:29 pm
Just wanted to point out that the picture shows an AT4, not an LAW.
Posted: Mon Apr 23, 2007 2:44 am
my bad... ok.. loads of ideas but ill stick to thrasmussen's flange thingy and the bell reducer stuff.. tks guys! the LAW will be shown soon, i promise. 
Posted: Mon Apr 23, 2007 7:12 am
the anti tank weapon in that picture is an actual LAW tube that has been fired and discarded. The military sells them for cheap because they typically cant be reused, or its just not economical to refit them.
As for what to use, I say hit up a rubber store and find out where the hard and dense packing rubber is. At my uni they have shitloads of it being thrown away, not exactly sure where it comes from but its rubber and is nice and hard. perfect for a replica LAW
As for what to use, I say hit up a rubber store and find out where the hard and dense packing rubber is. At my uni they have shitloads of it being thrown away, not exactly sure where it comes from but its rubber and is nice and hard. perfect for a replica LAW
Posted: Fri May 11, 2007 10:25 am
dose anyone know how hoe to lab a 81 mm practice round that means ineart mortar shell out of a cannon ? and to answer his problem just buy a reducer and cut off the straight part after the angle slope sorry if thats hard to understand.
Posted: Fri May 11, 2007 10:49 am
?dose anyone know how hoe to lab a 81 mm practice round
Posted: Fri May 11, 2007 11:12 am
well do yop i'm thinking a plug or wadding behind it
Posted: Mon Jun 18, 2007 6:40 am
Listen To Revenge 
P.S. Where the hell are the moderators now?
P.S. Where the hell are the moderators now?