Airsoft Sniper

[spudthug]

what do u mean? put a tiny orning on the inside of my barrel???

[VH_man]

no, right at the end. honestly, just dent it a little bit. either that or superglue/epoxy a peice of magnet wire to the back. its like .02 mm wide, and it can (amazingly) take the grunt of 150 PSI smashing into it. probobly better for your barrel than denting it.........

[spudthug]

magnet wire?? oh and i already found a way to stop it like 2 hours ago..i took a pair of plyers and squeezed at the end of my barrel a little..

[VH_man]

well that works too........ lol.........

[spudthug]

yea it works great and you cant even tell its there..not even from up close.. the only way you can see it is if you loook down the barrel...

it just stops the bb and i mean just stops it.. you could for it through if u wanted to but this works really good and i ddidnt have t odo anything to make my barrel crappy

[ammosmoke]

I meant at the beginning of the barrel, but whatever......

I meant that you should glue an o-ring on the end of the barrel that has the same OD, but a slightly smaller ID. Sorry, that wasn't very clear.