Posted: Sun Apr 15, 2012 4:31 am
very nice spark plug!
thread 1/8 NPT-BSP?
shooting a 18x looks great!
Page 21 of 61
Posted: Sun Apr 15, 2012 1:03 pm
Posted: Sun Apr 15, 2012 1:08 pm
You said BSP no?Petitlu wrote:thread 1/8 NPT-BSP?
Posted: Sun Apr 15, 2012 1:09 pm
Great to see JSR being very proficient at designing for machineability!
His epoxy stash is going to reach its "expiration date", due to his new found capabilities!
His epoxy stash is going to reach its "expiration date", due to his new found capabilities!
Posted: Sun Apr 15, 2012 1:17 pm
Yes BSP!
I had not realized it was this beautiful spark plug for me!
you are too generous!
Thank you!
I had not realized it was this beautiful spark plug for me!
you are too generous!
Thank you!
Posted: Sun Apr 15, 2012 1:24 pm
You may have spoken too soon, apparently he has still thrown in some epoxy in there for good measureHis epoxy stash is going to reach its "expiration date", due to his new found capabilities!
Posted: Sun Apr 15, 2012 1:30 pm
As to marine epoxy, that might actually be true!dewey-1 wrote:His epoxy stash is going to reach its "expiration date", due to his new found capabilities!
Araldite application is easier than o-ring groovesYou may have spoken too soon, apparently he has still thrown in some epoxy in there for good measure
I had not realized it was this beautiful spark plug for me!
I don't want you to have any excuses for not shooting at 40x
Posted: Sun Apr 15, 2012 1:54 pm
Mix 50 would be dangerous? 
Posted: Sun Apr 15, 2012 2:21 pm
paintball tanks usually have 5000 psi burst disks, I think you'd be pushing your luckPetitlu wrote:Mix 50 would be dangerous?
Posted: Sun Apr 15, 2012 2:32 pm
yes, but the tank is pierced less resistant ...
Posted: Sun Apr 15, 2012 2:34 pm
Exactly, so stick to 40x
Posted: Sun Apr 15, 2012 2:38 pm
it's true!
Mix40 is already very powerful!
Mix40 is already very powerful!
Posted: Sun Apr 15, 2012 4:56 pm
Just wondering if anyone has any qualms about using brass fittings at 40x mixes?
Posted: Sun Apr 15, 2012 5:02 pm
I have brass fittings provided for 5000psi ....
Posted: Sun Apr 15, 2012 5:04 pm
In that case you may proceed to 40x