Posted: Wed Apr 01, 2009 9:01 am
yikes.. my bad. It's been a while since i've been to the site and went into my bookmarks to post the link. sorry about the confusion there. Bob does build some nice airguns, though.Gippeto wrote:Nope. That's 900fps for the 308 bandit. And around 500ft.lb for the .50cal.A big bore conversion and tune from him (specificaly, the Quackenbush 308 bandit) can yield 900+ ft.Lbs. of energy from a projectile! Yikes!
Not even close.
As for the high pressures, yes, I also think that unregged CO2 would be considered the upper eschelon, but I differ in the opinion in that HPA is still quite cost prohibitive. While some paintball enthusiasts use it, in my experience, it's only hardcore players that use such equipment. I've been playing for over 15 years, and I still run CO2; it's way more cost effective. It's also easier to get CO2 bottles filled than HPA in most areas. (For example, the local hardware store can fill CO2, but not HPA)
What about nitrogen? that seems to be gaining some popularity as well as becoming more accessible, I see a lot of players running nitrogen as opposed to HPA. Doesn't need to be paintball equipment exclusively; I saw this at Harbor Freight, for example:
http://www.harborfreight.com/cpi/ctaf/d ... mber=97061
...plus, any welding supply should be able to fill it, right? Then again, most people I know run CO2 through their welders because it's cheaper and lasts longer; Some say it even shields better too
not too many people run HPA or nitrogen in spudguns yet, but I think you're right in regards to bulk CO2, it seems like the next big thing. Even I've been considering buying a CO2 Regulator for spudding purposes; Might be nice for paintball too. It's way more cost-effective if a purchase can serve double duty. Still, I'm hesitant about running it unregged, except for my paintball gear, which is designed to handle it, of course.