1" Piston

[n-strike]

iisthemuffin, yes I do know that there's no way of taking it apart, but I meant like...there's a little space in between the bushing at the tee, so maybe I could saw that off, and then sand the inside oh the tee to make it normal again. Just an idea.

[MrCrowley]

You can remove fittings, but it's hard to do it when the fitting is on the inside. Try getting a jigsaw blade and sawing the bushing from the middle to where it meets the tee's socket. So essentially you are sawing the radius of the bushing. Then get a hammer and a flat head screw driver and start banging in between the gaps.

[n-strike]

Oh...that sounds awesome. I have to try that. Thanks a lot, MrCrowley! <3

[battlemonkey]

When I take PVC apart I cut the PVC pipe down to where it enters the fitting, then cut a slice through the pvc pipe on the inside of the fitting. Then get a chissel and wack it with a hammer on the join between the pvc pipe and fitting. Works most times for me.

[n-strike]

Alright, thanks battlemonkey.