Page 1 of 1
My new piston valve
Posted: Wed Sep 19, 2007 8:09 pm
by iPaintball
I just finished this piston valve. It's not my first, but It's the first one I could post.
Here's the whole valve:
It has a 1" port:
The seat:
Dissasembled:
Posted: Wed Sep 19, 2007 8:35 pm
by chartreusesnot
dood thats a really cool piston. Its kinda pill like, too bad the tee isn't transparent.
Posted: Wed Sep 19, 2007 8:37 pm
by MrCrowley
This section is for my designs and plans to a new theory, a piston valves operation is a theory, but it's an old one, this is more for like if you figure out how to make a semi-auto valve.
Posted: Wed Sep 19, 2007 8:39 pm
by iPaintball
Oh, I just saw Accesories, so I posted it here.
Posted: Wed Sep 19, 2007 11:31 pm
by CannonCreator
whats the sizes of Tee, and piston endcaps? did you sand out the middle of the Tee or did the endcaps for the piston just fit?
Posted: Thu Sep 20, 2007 3:07 am
by iPaintball
The tee is 1.25" and the endcaps are 3/4". The piston travels in a piece oh 1.25" pipe
Posted: Fri Sep 21, 2007 8:18 pm
by noob of noobs
Wait a second, what's your pilot valve? I see a schrader on the back cap, but not a blowgun or ballvalve. Are you just opening the schrader manualy?!?
Posted: Fri Sep 21, 2007 8:37 pm
by chaos
umm thats not a shrader...
looks to me like a nipple where he would then either attach a blowgun or ball valve.
Posted: Fri Sep 21, 2007 8:53 pm
by iPaintball
I have a 1/4" QEV which threads onto the nipple on the back.
Posted: Sat Sep 22, 2007 1:52 pm
by noob of noobs
Ah, I see.
Do you have a gun for that yet?