SpudFiles

alright, i hooked my laser up with a switch, and then cased it in some 3/4" electrical conduit and put a coupler on the end.. now i want to mount it to my gun.

I want to be able to move it so its accurate, then make it stay there and not move. would hose clamps be suitable to this? what else could i use?

here are some pics

I tried hose clamps but they didn't work so well for me.
Why not rig up a simple device so it sticks onto the gun, then you can move the laser up and down, left and right but tightening a screw to lock the laser in place.

It shouldn't be too hard

it SHOULD be too hard for me.. not so good with that type of stuff lol.

I used electricians tape to secure my laser to my BB rifle. Because electricians tape is a bit stretchy, I could "tune" the laser as so that it would point where my barrel did, after tuning it, I added more tape to keep it in place. Looks a tad bit messy, but works a charm.

Yeah, as Infernal Maveric said, Duct tape would work really well. I did that to mount a scope on one of my guns, and i works really well.
Duct tape would definitely do the trick.

bleck. you can always buy a laser that has adjustments. UTG sells one....... i have one on my airsoft GBB.

anyway, what i would do is mount it at the rear, and then have some bolts screwed into some wooden blocks to allow for adjustments.

im going to file the ends so its flat and then glue it onto my sprinkler.