Page 1 of 1
Pistion Gauge Question
Posted: Wed Jan 02, 2008 7:30 pm
by elitesniper
Hey guys i have a question about the gauges on the pistons well if you attach the guage on where the exhaust area is instead of the chamber area will the psi's be the same as if you added it on the chamber?
Posted: Wed Jan 02, 2008 7:34 pm
by jrrdw
Yes, if it equilizes like it's sapossed to.
Posted: Wed Jan 02, 2008 7:35 pm
by MrCrowley
Yes......
Edit:
Damn, beaten to it
Posted: Wed Jan 02, 2008 7:38 pm
by sandman
yes, but yo have to let it set for a couple of seconds
Edit: sniped
Posted: Wed Jan 02, 2008 8:12 pm
by elitesniper
Hey MrCrowley imma take your advise and use the sprinkler for my exhaust
are you sure its guna be loud? here is a pic of the gauge , and the exshaust is some thing like this right?
[/img]
Posted: Wed Jan 02, 2008 8:19 pm
by MrCrowley
Wow, isn't your tee only 1.5"?
It will work well, but a tad over-kill
Mine's in a 2" tee.
Yeah, but where's your fill valve?
And are you just going to bolt it on and have the piston in the pipe at the end?
Posted: Wed Jan 02, 2008 8:23 pm
by elitesniper
no ima going to put a threaded adapter the reducing it to 1 inch for my sprinkler heres how its going to be set up ill buy the threaded adapter and reducing bushing tomro though
the threaded part so its servicable[/img]
Posted: Wed Jan 02, 2008 8:28 pm
by MrCrowley
Ah okay, pilot volume would be a bit big but your sprinkler valve takes good care of that
