Page 1 of 1
Safety of Fittings
Posted: Sun Jan 13, 2008 2:03 am
by TheTrooper
Okay, so i was gluing together my new pneumatic (which is now done, will post soon) when i accidently glued a 45* angle fitting on backwards(the side without primer) I immediately twisted off with a vice but my question is: Is is still safe to re-glue this fitting because of the glue residue left on it before?
Posted: Sun Jan 13, 2008 2:34 am
by SpudBlaster15
Lorem ipsum dolor sit amet, consectetur adipiscing elit. Cras nec placerat erat. Vivamus dapibus egestas nunc, at eleifend neque. Suspendisse potenti. Sed dictum lacus eu nisl pretium vehicula. Ut faucibus hendrerit nisi. Integer ultricies orci eu ultrices malesuada. Fusce id mauris risus. Suspendisse finibus ligula et nisl rutrum efficitur. Vestibulum posuere erat pellentesque ornare venenatis. Integer commodo fermentum tortor in pharetra. Proin scelerisque consectetur posuere. Vestibulum molestie augue ac nibh feugiat scelerisque. Sed aliquet a nunc in mattis.
Posted: Sun Jan 13, 2008 2:49 am
by spudy buddy
ya on most cementing guides and FAQs it says "if the glue hardens reaply on both the pipe and the fitting" so i'm guesing there would be no harm in using it.
Posted: Sun Jan 13, 2008 2:56 am
by TheTrooper
Allright thanks! Because i would be very mad if i had to buy stuff again!
Posted: Sun Jan 13, 2008 3:05 am
by spudy buddy
no you wont but like spudblaster said if it built up than gently sand it off.