SpudFiles

the epoxy i bought does not seem to work, so i was wondering if it would be possible to just fill the hole with a glue from a hot glue gun? if not, what other substances can be used that i might find laying around my house?

did you mix it in the correct ratio?

the stuff i bought is one container, that has two holes at the top. I pressed both equally until it was full and then i swirled it around and it has not dried yet after two days...

Well hot glue will not work it will blow out at like 20psi.

mix it till it changed color

alright thanks ill try that again

Depending on how thick it is, it will take longer to dry.

I used plumbers epoxy for my first one. It said it dries in 24 hours and gets hard like steel. But it didnt finish drying until the 3rd day. So you just gotta wait it out.

k ya i just reapplied it so ill just have to wait it out like you said thanks guys

i put hot glue on mine and run it at 80 psi it works fine

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Cras nec placerat erat. Vivamus dapibus egestas nunc, at eleifend neque. Suspendisse potenti. Sed dictum lacus eu nisl pretium vehicula. Ut faucibus hendrerit nisi. Integer ultricies orci eu ultrices malesuada. Fusce id mauris risus. Suspendisse finibus ligula et nisl rutrum efficitur. Vestibulum posuere erat pellentesque ornare venenatis. Integer commodo fermentum tortor in pharetra. Proin scelerisque consectetur posuere. Vestibulum molestie augue ac nibh feugiat scelerisque. Sed aliquet a nunc in mattis.

That would make sense woukdnt it?

I've heard that the solenoid is a bit leaky, and that can REALLY mess up your valve.

the solinoid in my modded valve held 100psi for 3 hours with only a 10 psi drop because of a leaky valve to begin with

my solenoid was the biggest leak on my valve, solved that with the epoxy

pizlo wrote:I've heard that the solenoid is a bit leaky, and that can REALLY mess up your valve.

I've never had that problem.