SpudFiles

I know its basic but you asked to see my work!!!!



A screw here....


Blow valve where the silonid was....



And NO epoxy....

EDIT:
This is a 1" orbits jar top valve. I installed a modded blow gun ( drilled bigger hole in the brass fitting), a pressure gauge and a schrader valve. The gauge and schrader are tapped into a steel nipple. I prefer the jar top because they are easier to modd.
The rest of the cannon is being painted..

Nice, but it doesn't belong in the showcase section.

Nice job.
Its also nice to tap the gauge into your valve.

Nice, but what size is the valve?

I don't get it, did you mold the valve and build it? Or just tap it for the blowgun and gauge?

I really like the idea of putting the gauge, and schrader on the sprinkler it seems cleaner(though that valve is a little dirty). Not needing to tap into the chamber is a good thing too even if you would do it through a double layer.
Ill do the same with my next cannon

I don't use teflon tape cuase it sucks.....I use "RETOR SEAL" it is a thick paste, when you use to much it gets sucked into the valve..

I use teflon but ill have to try this retor seal stuff Ive never used any of the pastes.