Page 1 of 1
Can I reverse Solvent welding?
Posted: Sat Mar 08, 2008 9:44 am
by Counterstriker
I made a cannon the other day and I used a really good shrader.. I only have the rubber ones now(no not the ones for bikes) and they can only go to 50 psi.. I was aiming for 100.. Is there any way I could reverse solvent welding instead of sawing it off...
Posted: Sat Mar 08, 2008 9:48 am
by bigbob12345
No(message to short)
Posted: Sat Mar 08, 2008 9:56 am
by mopherman
Ypu can take the rubber ones to 100. Maybe a little epoxy reiforcement?
Posted: Sat Mar 08, 2008 10:22 am
by jrrdw
Why not pull it out with pliers and use a thin piece of wire to feed a new through the hole.
Posted: Sat Mar 08, 2008 4:33 pm
by base45
i use the rubber ones and i have got it up to 125 with no problem, but i did have quite a bit of epoxy to reinforce it.
Posted: Sat Mar 08, 2008 4:39 pm
by Counterstriker
Thanks anyway. I just got a dremel and cut it open. There goes my second cannon.
Posted: Sat Mar 08, 2008 5:05 pm
by starman
Dang man, why don't you just buy another schrader...unless I guess if your other cannon was truly worthless.
Posted: Sat Mar 08, 2008 5:15 pm
by Counterstriker
starman wrote:Dang man, why don't you just buy another schrader...unless I guess if your other cannon was truly worthless.
It was pretty lame. Just a gay ball valve.