Page 1 of 1
Reverse blowgun?
Posted: Sat Mar 22, 2008 3:09 pm
by Counterstriker
I was at lowes and once again they didn't have the right reducers..So I had to settle for a 1/8" to connect the blow valve. The end part of the blowgun is 1/8" inch. Could I connect it to the bottom of it? Will it still work to the same psi? I know I should get the 1/4" but I want to know if what I have will work..
Posted: Sat Mar 22, 2008 3:54 pm
by iknowmy3tables
yes yes but its not as fast opening, and you make have to remove one of those retarded safety nozzles
Posted: Sat Mar 22, 2008 4:18 pm
by Counterstriker
iknowmy3tables wrote:yes yes but its not as fast opening, and you make have to remove one of those retarded safety nozzles
Thanks a whole bunch!
[question resolved]