SpudFiles

i made this on paint.. but who can come up with the same thing but better and spoon feed me? lol...

basically what i showed you above is that the center pipe will slide out.. along with the reducer.. there fore stabilizeing the barrel by having two at the end at all times.. you will grab the first reducer and use that to extend the barrel out of its collapsed view.. but my only problem is now the chamber is too big.. anyone have suggestions? so this could be more like a law than most peoples designs?

anyways.. looking forward to your negative and postive posts...

Chamber doesnt seem too bad. Its over 1:1, which is just great for big bang and flames. If you want a longer barrel, then just have it stick out farther than the chamber covers up. Make sure your couplings are very very strong.

i think this would be more of a taditional law.. than most peoples.. because the major thing about makeing a law look like a law.. is being collapable.

is this a better design?



this would make the chamber smaller.. and would make the barrel longer ... sorta.. wouldnt it?

Just take the smallest pipe possible as chamber where the barrel still fits in.
Sleeved pipe would be the best, and yield a near 1:1 ratio.

im not following what your saying psycix?

--