SpudFiles

hi this is my gun
it's only a gun for short time because I am waiting for parts for the coaxial I want to make and then I need this parts again
the pressure I use is 120-140psi(8-10bar)
shots were from only a few metres

specs:
chamber is 22mm and almost 50cm long
barrel ID is 16mm and about 80cm long
ball valve is nothing special but has very good flow

It looks good. you can probably take it a lot higher than that. Is it just me or is it bent in the middle? I would also upgrade the ballvalve

yeah it was bent but I fixed it
higher is almost impossible with the pump I use
and yeah it's only till I get my new parts so I will keep it like it is and then it becomes a shorter and thicker(28mm) coaxial