SpudFiles

Ok, i'm re-making my mini coaxial and i need to know how people make those perfect epoxy bushings and stuff. My last method worked, but was a waste of materials and volume.

(JSR i'm talkin to you)

Well, you could use some small vice grips to center the barrel in the chamber while you poured and cured the epoxy.

EDIT - nevermind, I see what you're saying.

I think JSR uses rubber in his pours, but don't take my word for it.

ALSO, I believe he has a few posts in the How-To section as well.

EDIT 2 - http://www.spudfiles.com/forums/epoxy-c ... t8916.html

As mark linked to above, it's pretty much all explained in the how-to. It's also not too difficult to make jigs to ensure that everything is centred, wrapping tape around a cylindircal object is a very straightforward way of doing this.