XRV explosive release valve
Posted: Sat Mar 14, 2009 8:17 pm
once again, not mine, but a really good idea found completely randomly on youtube [youtube][/youtube]
Page 1 of 1
Posted: Sat Mar 14, 2009 8:21 pm
Once again, this has been previously posted and was made by someone on this site.
Posted: Sat Mar 14, 2009 8:26 pm
really, i searched and dindn't find anything?lctchamp wrote:Once again, this has been previously posted and was made by someone on this site.
Posted: Sat Mar 14, 2009 9:14 pm
Posted: Sat Mar 14, 2009 9:52 pm
I had no idea that instructables was owned by Spudfiles..... hmmmmm......
Posted: Sat Mar 14, 2009 10:29 pm
Thats a great idea. That could be made LARGER.
Posted: Sat Mar 14, 2009 11:42 pm
Alright, I apologise for posting a link to an instructable that was very much directly related to the topic and using three dots because my post was to short and to trail off.brogdenlaxmiddie wrote:
I had no idea that instructables was owned by Spudfiles..... hmmmmm......
Will you ever forgive me
Posted: Sat Mar 14, 2009 11:54 pm
The reason I was being sarcastic was because you said that it had been posted on this website (being www.spudfiles.com) and that he should have "searched". You then prove him wrong and post a link to instructables.com.... not spudfiles. That's why I was being a dick about it.
Edit- I realized now after re-reading the previous posts, that you in fact were innocent. I apologize.
Edit- I realized now after re-reading the previous posts, that you in fact were innocent. I apologize.
Posted: Sun Mar 15, 2009 12:58 am
That's fine, I was just wondering what you were on about.
I built something similar, and also one where I used a hacksaw and a file to create larger, straighter cuts (holes) for the air to go through. The one with the hacksawed air openings worked much better, so I'd recommend that for anyone who wants to make one.
I built something similar, and also one where I used a hacksaw and a file to create larger, straighter cuts (holes) for the air to go through. The one with the hacksawed air openings worked much better, so I'd recommend that for anyone who wants to make one.
Posted: Sun Mar 15, 2009 7:55 pm
stop arguing, holy crap all i did was post a video?
Posted: Sun Mar 15, 2009 10:35 pm
What the McFook is everyone going on about? Get over yourselves. That's a great looking valve. Size for size, I wonder how it compares to a piston valve. I think I may have to try this after remembering that my aluminum 8mm barrel sleeves perfectly into 1/2'' copper tubing. Question, this is a glorified poppet valve right?
Me thinks it would make an awwwesome large bore pilot
.Posted: Mon Mar 16, 2009 2:03 pm
Bad. This is not much different then a homemade blowgun*.I wonder how it compares to a piston valve.
*To avoid confusion, with this blowgun, I do not mean blowgun as a pipe you put your mouth on and blow like he uses the word in his video, but the one we spudders use to pilot sprinklers and stuff.
On larger diameters and high pressures, this valve will become VERY hard to push in.
Posted: Mon Mar 16, 2009 6:42 pm
Yeah that was what I first thought. Either way I still reckon I'll give it a go. I've made just about everything there is when it comes to pneumatics .
.