SpudFiles

Posted: **Sun Jun 28, 2009 2:47 pm**

I drill a hole lightly larger than the beginning rubber taper diameter of a tubeless tire fill valve and push it through the hole from the inside.

No threads, no adhesives.

The compressed air makes it seal perfectly.

My question: How many PSI will a Shraeder valve take?

BoyntonStu

Posted: **Sun Jun 28, 2009 3:06 pm**

More than you will ever need.

Gippeto tested a threaded one to over 300 bar. You'd have to worry about the tubeless valve popping out before it actually fails.

Here's the thread: http://www.spudfiles.com/forums/the-fai ... 15393.html

Posted: **Sun Jun 28, 2009 3:14 pm**

you would have to worry about you cannon blowing up before it fails lol

SpudFiles

Shraeder valve mounting and a question.

Shraeder valve mounting and a question.