SpudFiles

Long Time no Post,

I've been busy with school work, but I'm going to get back into it soon after the final year is out .

Anywho... I was planning to make a compact rifle that could fire multiple shots using small projectiles about 6mm or less. And so I decided to make a Brass Fittings air chamber by just combining a whole bunch of fittings to eventually make a small air tank...

I was then going to buy a 50 dollar shock pump to pump iit up to 300-400PSI~ and plink to my heart contents.

But the question is that can Brass Fittings hit a high pressure without it exploding?

Brass will easily hold all the pressure a shock pump can put out. Anything up to 700-1000psi should be perfectly fine. After that you simply have to check.