i have a cheap grizzley pellet gun(one pump) i was thinking that if i replace the piston casing with a copper one of the same diamiter and put a check valve on it then i was thinking i could get more power out of it what do you all think?
allso how could i make it so i could pump it more then one time?
super powered pellet gun
-
jackssmirkingrevenge
- Five Star General
- Posts: 26219
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 581 times
- Been thanked: 347 times
It probably has a hammer valve, in which case pumping it up to higher pressure means the valve will encounter more resistance to opening and will actually decrease power.
You should look into increasing barrel length and fitting a stronger hammer spring.
You should look into increasing barrel length and fitting a stronger hammer spring.
hectmarr wrote:You have to make many weapons, because this field is long and short life
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 5 Replies
- 2172 Views
-
Last post by psycix
-
- 3 Replies
- 2899 Views
-
Last post by inonickname
-
- 4 Replies
- 1577 Views
-
Last post by SpudStuff
-
- 9 Replies
- 3606 Views
-
Last post by Killjoy
-
- 0 Replies
- 1768 Views
-
Last post by SEAKING9006
