Page 1 of 1
Recoil Reducer
Posted: Fri Mar 05, 2010 4:49 pm
by Gun Freak
For my next gun, I am thinking about modeling it after the Barret 50 caliber sniper rifle:
It will be another co-ax. Im thinking that if I sleeve the chamber with larger pipe, and put a rather weak spring behind the internals, it can reduce if not eliminate recoil, and it would look pretty cool
I know it doesn't sound doable, but I was designing it all day and I think I have an idea. What do you guys think?
Posted: Fri Mar 05, 2010 5:52 pm
by maverik94
For my next gun, I am thinking about modeling it after the Barret 50 caliber sniper rifle:
It will be another co-ax. Im thinking that if I sleeve the chamber with larger pipe, and put a rather weak spring behind the internals, it can reduce if not eliminate recoil, and it would look pretty cool I know it doesn't sound doable, but I was designing it all day and I think I have an idea. What do you guys think?
Your link does not work.
Posted: Fri Mar 05, 2010 5:54 pm
by jrrdw
Well sound's good but I would like to see a diagram or similar...
Posted: Fri Mar 05, 2010 6:40 pm
by Gun Freak
maverik94 wrote:Your link does not work.
I didn't insert a link.
Here's a sketch of the design... ask if you need clarification on something because it may not be very explicit.
The thing under the WEV is a hose barb.
Posted: Fri Mar 05, 2010 6:54 pm
by Demon
Posted: Fri Mar 05, 2010 7:05 pm
by Gun Freak
Does that use the same principle?
Posted: Fri Mar 05, 2010 7:15 pm
by Demon
The sheytac would be simpler to build and you dont need to care about recoil (Id'say you want recoil)
Posted: Fri Mar 05, 2010 7:46 pm
by Gun Freak
Yeah I want recoil but I also want a way to absorb it. It's just a cool idea to me. And yeah, the pic was working on my desktop but not on my laptop. I'll change it.
Posted: Fri Mar 05, 2010 7:52 pm
by Demon
After i will have made my 6mm carbine, i will make a chamber sealing ball bearing airgun that looks like an cheytac (some small differences tough) .
Does anybody has an idea of the recoil of a .5" ball bearing at 480 fps?
and again, no need to absorb the recoil ... seriously
The recoil would be less then a 9 mm
Posted: Fri Mar 05, 2010 10:17 pm
by Gun Freak
ok then... scratch this idea
Posted: Fri Mar 05, 2010 11:30 pm
by c11man
@demon
the recoil is very small, i shoot .625in ball bearings at 750fps with just the qev resting on my shoulder and im a bit of a wimp so a .5inch bearing will be just fine
