Page 1 of 1
Placing of a schrader valve
Posted: Wed Aug 24, 2011 2:55 pm
by jsefcik
I just got a barrel sealing piston valve,
Im just stuck on where to put the scharder valve,
Two questions? can i put it in the bottom of my blow gun?
And if not where on my sprinkler valve can i put it?
I dont wanna use brass tees i think it looks crappy
please help!!!!!!!i want to build this beast!!!!
Posted: Wed Aug 24, 2011 3:14 pm
by wyz2285
NOT in the bottom of your blowgun
you are using a sprinkler valve to pilot it? if so you can put it on the valve in the same place as the blowgun I think, search a little for examples
Posted: Wed Aug 24, 2011 3:19 pm
by mattyzip77
Why not?? As long as he depresses the blowgun while filling, it should work???
Posted: Wed Aug 24, 2011 3:43 pm
by streetfire
but if the blowgun pilots the sprinkler an schrader will not work properly because of the flow through the schrader. just drill a hole tap it and place it with epoxy works great
Posted: Wed Aug 24, 2011 3:53 pm
by mattyzip77
actually, you just take the core out of the schrader valve!!
Posted: Wed Aug 24, 2011 4:00 pm
by streetfire
that will work but if he is pumping wont it be hard too keep pressing the blowgun?
Posted: Wed Aug 24, 2011 4:02 pm
by mattyzip77
He has a compressor, no pumping needed, but that was a good point!!
Posted: Wed Aug 24, 2011 4:32 pm
by jsefcik
Im talking to gun freak on how to put it into the side of the sprinkler valve
Posted: Wed Aug 24, 2011 4:46 pm
by mattyzip77
jsefcik wrote:Im talking to gun freak on how to put it into the side of the sprinkler valve
Drill a hole, tap the hole, insert schrader valve, done!!
Posted: Wed Aug 24, 2011 4:50 pm
by jsefcik
mattyzip77 wrote:jsefcik wrote:Im talking to gun freak on how to put it into the side of the sprinkler valve
Drill a hole, tap the hole, insert schrader valve, done!!
im just talked to him, im going to do it in a bit