SpudFiles

I want to make this semi-auto so i can shoot multiple bbs

OK. whats stopping you?

There quite a few ways to get semi auto, but anyway, where's your fille valve?

Im not quite sure how. i poked a hole in the piston and put a spring behind it but its terrible so i took the spring out.


and my fill valve is in the bottom of the blowgun i screw a custom valve into it which goes to my compressor.

if you are using that blowgun as a pilot, you really should make your gun like thishttp://www.spudfiles.com/forums/semi-au ... 21406.html it´s simple, easy to make, and in my opinion better than a 3 way valve or a slide valve, you will be able to adjust the number of shoot and power.
Here is a video:
[youtube][/youtube]

Please could you show me how your semi auto blowgun works!

well some people were able to make a copy from this video
[youtube][/youtube]

3 way valve connected to the QEV, but that's only one of the ways

slide check? i have seen JSR post it but i dont understand how they work

Goats spudz wrote:slide check? i have seen JSR post it but i dont understand how they work

like the pilot valve in this pic.

ok thanks but i have seen these on ebay with a QC on em will that connect to a male pcl qc

just curious can someone show a slide check in use, with a QEV

the rifle that jack linked you to worked very well.

I did notice however, the slide valve seemed harder to trigger at very high PSI, such as 350+ psi. A little bit of mineral oil seemed to help alot.