SpudFiles

Hi

This is a valve I have design


for this gun
http://www.spudfiles.com/forums/viewtop ... tml#320233

The reason being it will be used with an external HPA kit and I want to save as much air as possible.

With the blow gun trigger it wastes a lot of air.

I have tried to make this, but without a lathe have not been able to get to seal.

I have brought this Clippard Valve, but it takes way to long to reset


Below is how my design should work



Will this work

Does anyone know of a manual pulse valve that would do the job?

I have brought this Clippard Valve, but it takes way to long to reset

that's an air actuated valve right ?? can't you unscrew that reserviour on it?? that's essentially what controlls time delay