SpudFiles

i have an o-ring piston,with bolt and washer,
looking for new bumper ideas, tennis ball sucks doesnt last long enough


please help

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Cras nec placerat erat. Vivamus dapibus egestas nunc, at eleifend neque. Suspendisse potenti. Sed dictum lacus eu nisl pretium vehicula. Ut faucibus hendrerit nisi. Integer ultricies orci eu ultrices malesuada. Fusce id mauris risus. Suspendisse finibus ligula et nisl rutrum efficitur. Vestibulum posuere erat pellentesque ornare venenatis. Integer commodo fermentum tortor in pharetra. Proin scelerisque consectetur posuere. Vestibulum molestie augue ac nibh feugiat scelerisque. Sed aliquet a nunc in mattis.

Rubber, open-cell foam, garden hose to name a few...

This is going to sound insulting, but I actually find that the polymer which dildo's are constructed of make a perfect bumper!

MrCrowley wrote:Rubber, open-cell foam, garden hose to name a few...

how a garden hose????

was thinking of rubber washers but lots of them on the back but dont want them too big, see act as a seal but just build it up with rubber washers would that work

how a garden hose

Cut a small section off and fold it inside the housing.

was thinking of rubber washers but lots of them on the back but dont want them too big, see act as a seal but just build it up with rubber washers would that work

Texts from Bennett are easier to understand than this sentence, just saying.

I didn't understand either

Jsefcik, how about a strong spring and some rubber to prevent damage to the piston? You could use rubber washers to soften the hit and then the spring can take the rest.

Gun Freak wrote:I didn't understand either

Jsefcik, how about a strong spring and some rubber to prevent damage to the piston? You could use rubber washers to soften the hit and then the spring can take the rest.

that what i was going to use the rubber washers for

just wondering would it be strong enough

You never mentioned a spring.

I wouldn't suggest it if I didn't think it was strong enough. It is, however, up to you to find the right spring. May be difficult.

Gun Freak wrote:You never mentioned a spring.

I wouldn't suggest it if I didn't think it was strong enough. It is, however, up to you to find the right spring. May be difficult.

if i get enough rubber washers and build it up enough, i think it might work

not gonna use a spring

Don't just use rubber washers, they don't compress enough.

Gun Freak wrote:Don't just use rubber washers, they don't compress enough.

too hard you think

Open cell foam has worked best for me so far.
Closed cell foam breaks down and needs replacement. Use the dense foam. The core of a Poof brand football was used in my ABS test cannon.
Use a thick pad so the piston has a relatively long braking zone to soften the impact force at the end of travel.

mobile chernobyl wrote:This is going to sound insulting, but I actually find that the polymer which dildo's are constructed of make a perfect bumper!

"Silicone rubber" would have sufficed

jackssmirkingrevenge wrote:
"Silicone rubber" would have sufficed

Nah these dildos are quite unique dildos in that they are constructed of non-typical dildo material...

you see, I stuck a test specimen of these dildos into an x-ray diffraction unit and verified that their crystallinity was in fact unique from that of silicone dildo's.

In conclusion - these are special dildos which gives them the ability to absorb impacts in a bumper situation better than normal dildos.