Page 1 of 1
more accurate bbmg
Posted: Sun Jul 02, 2006 5:31 pm
by singularity
i jus built vortex bbmg, i used a 5/16 brake line for the barrel and when i fire it the bbs seem to spread out in a shotgun type pattern. is this because of the fire rate or the barrel. how can i make it more accurate?
ps i dont no if i should have posted this is this category or off topi so sorry
Posted: Sun Jul 02, 2006 5:43 pm
by Benny
No that is normal, How Long Is Your Barrel Tho?
Posted: Sun Jul 02, 2006 5:51 pm
by singularity
little over 3 feet
Posted: Sun Jul 02, 2006 6:40 pm
by saladtossser
tape the top of the barrel tip, that induces back spin
Posted: Sun Jul 02, 2006 11:08 pm
by singularity
that will make it more accurate? just a piece of tape
Posted: Mon Jul 03, 2006 12:23 am
by Benny
Thats how the hop-up works on BB guns. it kinda acts like rifleing.
Posted: Mon Jul 03, 2006 12:28 am
by singularity
well i try it tommarow on my bbmg, would rifling the barrel help? if so what would be a simple way to do it
Posted: Mon Jul 03, 2006 12:40 am
by Benny
There is no simple way to do it, but you can get a dowel rod and hammer a hell lot of nails in it and spin it around the barrel.
Posted: Mon Jul 03, 2006 8:36 am
by spudshot
longer barrel, make sure theres no burrs at either end of the barrel, you can also cut a thin channel in the end of the barrel on the top so it just cuts thru to the inside a tiny bit then put an o-ring on there, same idea as the tape, just cleaner and possibly more effective if done right