Page 1 of 1
New Piston Valve
Posted: Wed Jul 19, 2006 11:37 am
by LucyInTheSky
Future Plans, The main Tee is 28mm, the barrel 22mm and the pilot area 15mm
Think it will work? it made of copper.
Posted: Wed Jul 19, 2006 2:07 pm
by Atlantis
It's nothing new, I believe I've seen this design before, assuming the dark gray part is an exhaust valve, it should work.
Posted: Wed Jul 19, 2006 7:21 pm
by SpudStuff
yes that is an incredebly common design used on almost all copper guns
Posted: Thu Jul 20, 2006 3:19 pm
by Shrimphead
Looks good to me.
Posted: Thu Jul 20, 2006 3:37 pm
by LucyInTheSky
Do you guys think it will be worth using as aposed to just using a 1/2" QEV? It would increase flow etc but iv been told the QEV is better.