SpudFiles

does anyone know of a good way to get the butane setup out of a piezo lighter??? any suggestions???

Cut away the plastic with a hack saw piece by piece untill you get what you want out of it. Make sure it's empty first.

I think the easiest way to get butane out of a lighter is pressing the button.

Or drilling a hole in the side - but not with a power drill!!!
(In case you don't know - I'm joking!)

Just buy a lighter refill can.

cant you freeze the butane to a liquid, then pour it out? tell me if I'm an idiot

i would like to get the whole set up out so i can just toss it onto my new mini. ill post it once im done

how about a tube from the small funnel where butane comes out connected to the chamber?

pyromanic13 wrote:cant you freeze the butane to a liquid, then pour it out? tell me if I'm an idiot

yup, your an idiot

maybe if you used liquid nitrogen..... but i still dont think so, and how would you contain it?

hey zeig that might work. i might try that although that might not be compact enough for what im trying

If ya wanna tiny fuel dispenser, get one of those blue flame cigarette lighters, take it apart, replace the little hose that connects the mixing head with a longer one... It works well because it pre-mixes the fuel and air.

where can i get a blue flame cigarette lighter? and is it easy to take it apart?

Specialist wrote:where can i get a blue flame cigarette lighter? and is it easy to take it apart?

Most all gas stations have them, i got mine from ebay. Yes, they are easy to dismantle.

cool, ill try that unless this butane setup comes out relatively easy. thanks for the idea though

A-98 wrote:

pyromanic13 wrote:cant you freeze the butane to a liquid, then pour it out? tell me if I'm an idiot

yup, your an idiot

maybe if you used liquid nitrogen..... but i still dont think so, and how would you contain it?

eh...whatever I saw it on some directions on how to make hash. never tried it though because I didn't like the idea of inhaling something that had just been "soaked" in butane.

If you want to get the butane out in its liquid form, buy a computer case duster(I think its basically a can of co2) and turn it upside down and release the liquid c02 into a cup. then just through the butane canister in the liquid for a few minutes and it should be cooled to well below its boiling point, and you should be able to open it up safely. Remove it with a pair of tongs or pliers.

Wear gloves!!

I’ve measured the temperature of case duster gas to be -60F, but thats only because my thermometer doesn’t go any lower.
Butane boils at 31F, which means you could just throw it in the freezer, but it would return to gaseous state very soon.