Page 1 of 2
decisions
Posted: Sun Apr 22, 2007 2:53 am
by jon_89
ok i have posted a couple of questions but i cant decide what to do next.which one would you guys like to?either propane injection, a bbmg, a marble pnuematic, or a mini copper pnuematic that i will take to 200 psi?any ideas or suggestions are greatly appreciated. thanks
Posted: Sun Apr 22, 2007 3:01 am
by mega_swordman
I personally would like to see another marble sniper, though the copper pneumatic sounds like a good idea. It all depends on your preferences on types of cannons.
Posted: Sun Apr 22, 2007 3:03 am
by Pyro Ninja
look around...get ideas....make an oringinal gun
Posted: Sun Apr 22, 2007 3:13 am
by jon_89
i think i am going to go with the copper gun. it will most likly be a .5in chamber, .25in barrel, diaghram with blowgun and co2. i plan on shooting homemade darts. do you think this could go through a can from 75ft away?
Posted: Sun Apr 22, 2007 3:20 am
by Pyro Ninja
homemade darts would defiantly go through a can if made right
Posted: Sun Apr 22, 2007 3:44 am
by paddo
sounds like you have made up your mind and if i was you i would either go with the copper gun or the marble sniper.
best of luck to you
Posted: Sun Apr 22, 2007 3:55 am
by joe blogs
I would personally make a pneumatic bb gun with a modified nail gun valve, good scope and a gravity fed magazine.
Posted: Sun Apr 22, 2007 6:01 am
by mega_swordman
Could you make a gravity fed magazine with those nail darts. I just want to know if anyone has tried it yet. (sorry this is off topic, but it looks like he has a plan now.)
Posted: Sun Apr 22, 2007 6:19 am
by VH_man
What do you make the cones for those homade nail darts for? i make mine out of paper held toghether by superglue and they just rip apart before they exit the barrel!
Posted: Sun Apr 22, 2007 6:22 am
by Pyro Ninja
i make mine out of thin cardboard...cut the cone to size...put a nail through...then put hot glue in the back
Posted: Sun Apr 22, 2007 1:16 pm
by jon_89
i know this is a noob question but is there any other way to connect copper other than soldering?
Posted: Sun Apr 22, 2007 10:13 pm
by From_Hamsterdam
you could make a propane powered pneumatic marble mg made out of copper?
Posted: Sun Apr 22, 2007 10:20 pm
by super spuder
jon_89 wrote:i know this is a noob question but is there any other way to connect copper other than soldering?
metal glue will join copper will it not (JB weld or something like that)
Posted: Sun Apr 22, 2007 11:18 pm
by Hotwired
Look for JustForCopper, I joined the endfeed fittings on my cannon with it.
Posted: Tue Apr 24, 2007 9:38 pm
by jon_89
can somebody ggdt this gun because i cant get it to work.it will be a .5in by 8in chamber and a .25in by 24in barrel.it will a chamber sealing piston exhausted by a modefied blow gun.i plan on going to 200psi. if someone could tell me the fps it will be greatly appreciated.