SpudFiles

ok its a paint ball sniper with a 2" chamber, 3/4" CPVC barrel, 1/4" quick connect to fill and shredder. a psi gage a 3/4" sprinkler valve moded with a moded blow gun and bipod. now this gun is no ware near done just thout id show you all the early stage's of what im trying to do . all that it needs now is a bolt action,paint,hose clamps,silencer,and a hopper.


dose any body know how to make a bolt action for paint balls? im sorry but iv look all over this site and have found nothing but the poor mans breach.


ok now for sum pics!! woo hoo!!







































and thats it hope you like it and if you dont tell me why

Nice gun: ) You should of used zip-ties instead of all that electrical tape. But its still a sweet gun.

yes thats what the hose clamps are for but i think ill use those. thanks for the quick reply

Nice starting point... by the list of improvements, I can see that this is going to look very good when it is finally completed. I like the bipod; it looks both good and functional (the latter I can't be sure of, but oh well, looks are everything right ).

One suggestion that I have to you is to clean up your post of this cannon so that it is both legible and easy to understand, because I gotta say, I can barely understand what you are saying sometimes.

sorry about that. Im very new to this ill clean it the best i can ok?

<a href="http://www.spudfiles.com/forums/bolt-ac ... l">here</a> a thing on the bolt action breach

It looks nice but,
Do me a favor, pull out your Webster’s and look up “sniper” and see if you’ve used it properly, okay?

A suggestion:
If at all possible, relocate the quick-connect. I’m assuming you plan on using the chamber as a butt stock, if so the quick-connect is going to get in your way.

Nice gun for your first, but my only suggestion would be to relocate the bipod to further down the gun. If you actually use it in the prone position you prob will end up bending the barrel and take whatever accuracy you may have away.

Well first off I'd dump the CPVC(i think it is) and go to brass(.686" ID).It will help out accuracy a whole lot.Second put the quick connect somewhere in the mid section of the gun.Personal experience is that the last thing you want is to have a hose hanging down from your armpit.It is hard to maneuver with that thing hanging up on your shirt.And finally leave off the hopper.There is no use use for one, carry a few ten round tubes and single load them.It will help with the usability and balance if you don't have to lug a hopper on such a skinny gun.Looks good so far keep up the good work.

thank you goat. im going to be playing with this gun so i think i will try the 10 round tubes instead of the hopper. and 4 the barrel i think im going stay with the cpvc its very accurate. but on my next paint ball gun ill will use brass. and ill move the quick connect somewhere else if i can fint sum thing to plug the hole