Page 1 of 1
Leak.
Posted: Mon Jul 02, 2007 4:17 pm
by Intel Xeon
I recently began building a coaxial cannon but found, to my dismay, that I had ground the bushing too far. The pipe has about 3/4 mm of clearance through the bushing. Should I attempt to use epoxy to hold it in place, or just get a new bushing?
Posted: Mon Jul 02, 2007 4:19 pm
by homedepotpro
new bushing if it is that much space
Posted: Mon Jul 02, 2007 4:25 pm
by noname
Just use thicker or more cement on the joint.
Posted: Mon Jul 02, 2007 4:29 pm
by Intel Xeon
@ noname
Personal experience says that doesn't work. I'll just get the bushing when I get back from Korea.
Posted: Tue Jul 03, 2007 12:39 am
by Modderxtrordanare
If its only .75mm just put epoxy in there.
Posted: Tue Jul 03, 2007 1:08 am
by TwitchTheAussie
Yeah epoxy it I say. Its more cost effective