breach loading for painballs
Posted: Sat Jul 21, 2007 1:40 am
does anyone know the best setup for breach loading a 3/4 sch80 barrel that is fairly easy
Page 1 of 1
Posted: Sat Jul 21, 2007 2:27 am
search around for some ideas.
Posted: Sat Jul 21, 2007 3:00 am
look at poor mans breach in how to section.
Posted: Sat Jul 21, 2007 3:41 am
yer poor mans breech 4TW. drill a hole a little bigger than a paintball in your barrel and sleeve some bigger pipe over the hole to seal it, (electrical tape may be required.) hope all goes well.
Posted: Sat Jul 21, 2007 9:00 am
You could also do a ball valve breech, it works wonderfully on my paintball gun. 
Posted: Sat Jul 21, 2007 11:53 am
how complex do you want it? Because I have a really nice plan for you for a decent breech, but its a little more comlex than some breeches, but really "nifty". Must I post it for you?
btw, nice heading: "...painballs", its a better description than paintballs if you ask me
btw, nice heading: "...painballs", its a better description than paintballs if you ask me
Posted: Sun Jul 22, 2007 12:39 am
yes you must lol i can do some work.
Posted: Sun Jul 22, 2007 8:12 pm
i have a 3/4 cpvc barrel sch 40 tho. i simply sawed off a chunk on the top half of the barrel big enough for a paintball. then i took a coupler for that size pipe and sanded out the ridge on the inside of the coupler so that it can slide fully down the pipe. also you gots to sand the hole inside of the coupler so that it slides smoothly. it works great for me, easy to slide back and forth and you are garunteed that it seals it airtight. Plus it only cost me about 62 cents