View source for CO2 tank

'''CO2 tanks''' are used as pressure sources for pneumatic launchers. There are two principal kinds, paintball tanks and bulk tanks. In addition there are 12g [[CO2 cartridge]]s, which are only good for one fill of any sizeable chamber, and usually not cost effective.

The pressure of ~800 psi needs to be regulated down to a pressure suitable for spudguns, using a [[pressure regulator]] between the tank and chamber. Regulators are made to connect directly both to paintball and bulk tanks.


=Paintball tanks=

Paintball tanks come in sizes from 4 to 20 oz, which is the weight of the CO2 the tank can hold. The tank valve is either a pin valve, which is opened by screwing the tank into the fitting, or an on/off valve which can be opened and closed manually. They have a burst disk safety valve that will break and vent the CO2 if the tank pressure rises above a certain limit.

===Filling===

A paintball tank is usually filled from a bulk tank that has a built-in siphon, which will let out liquid CO2. A paintball [[fill station]] is connected to the bulk tank and has the neccessary valves and fittings to connect it to the paintball tank.

The tank needs to be cooled down before filling, the the internal pressure of the tank will then be less than that of the bulk tank, and the pressure will transfer liquid CO2 to the paintball tank. The tank should be weighed when filling, and not filled to a greater weight than the tank is made for. If the tank is filled to excess, the pressure can rize rapidly with increased temperature and rupture the burst disk of the tank. A full tank contains about 1/3 of its volume in liquid CO2.

=Bulk tanks=
[[Image:CO2 bulk tank.jpg|thumb|right|180px|A CO2 bulk tank]]
Bulk tanks come in a variety of sizes, and are sold for use in beer tapping systems, aquariums, welding, as fire extinguishers and more. Empty tanks are either swapped for full ones or refilled for a certain fee.