View source for Step 1 - Removing the Flash Bulb

<u><h3>Removing the Flash Bulb</h3></u>Note: it is also not necessary to remove the bulb. You can also cut one lead and leave it attached to the board. The end result is the same.
<br>
<br>[[Image:Camera_Flash_0.JPG]]

{{Navbox
| name  = Step 1 - Removing the Flash Bulb
| title = Installing a Camera Flash ignition
| body  =
[[Step 1 - Removing the Flash Bulb|Step 1]] ·
[[Step 2 - Drilling the Holes for the Ignition Coil Wires|Step 2]] ·
[[Step 3 - Before Adding the Relay |Step 3]] ·
[[Step 4 - Adding the Relay |Step 4]] ·
[[Step 5 - Adding the Ignition Coil and Spark Strip/Spark Gap|Step 5]] ·
[[Step 6 - Providing Power to the Relay|Step 6]] ·
[[Step 7 - Removing the Battery Contacts|Step 7]] ·
[[Step 8 - Adding a Battery Holder and Kill Switch|Step 8]] ·
[[Step 9 - Replacing the Charging Button|Step 9]] ·
}}

{{stub}}
[[category:Ignition sources:Camera Flash]]