Difference between revisions of "Spud cutter"
Saladtossser (talk | contribs) m (the second example was a 404) |
|||
| Line 5: | Line 5: | ||
However, there are deficiencies in the typical PVC 'cutter, mainly that it is a relatively soft material and therefore can neither be sharpened very well nor hold an edge. Many have attempted to counter this by: | However, there are deficiencies in the typical PVC 'cutter, mainly that it is a relatively soft material and therefore can neither be sharpened very well nor hold an edge. Many have attempted to counter this by: | ||
* Serrating their cutter. (Examples: [http://www.spudfiles.com/official_pics/loc_04.jpg]) | * Serrating their cutter. (Examples: [http://www.spudfiles.com/official_pics/loc_04.jpg]) | ||
| − | * Making them out of steel. | + | * Making them out of steel. |
| − | + | [[Image:Aluminum Cutter.jpg|left|thumb|250ps|An Aluminum Spud Cutter]][[Image:Slug cutter.jpg|right|thumb|250ps|A PVC Slug Cutter]][[Category:Accessories]] | |
| − | [[Category:Accessories]] | ||
Revision as of 04:46, 13 January 2007
A spud cutter or muzzle knife is used to cut produce to the diameter of the barrel. It can be made as an integral part of the barrel, or kept as a separate utensil.
It is made by beveling the outside of the barrel (or a pipe of the same inside diameter) until it forms a sharp edge. In combustions, is recommended that you add an inner chamfer to your launcher; this cuts a tighter fitting projectile, which increaes friction and therefore acts a bit like a burst disk, allowing the pressure to build before projectile starts to move.
However, there are deficiencies in the typical PVC 'cutter, mainly that it is a relatively soft material and therefore can neither be sharpened very well nor hold an edge. Many have attempted to counter this by:
- Serrating their cutter. (Examples: [1])
- Making them out of steel.
![[1]](http://www.spudfiles.com/official_pics/loc_04.jpg){kind=link}