3D printed golf ball dart tails (image attached)

Potatoes last one shot, so build reusable! Discuss ammo designs and ideas. Tough to find cannon part or questions? Ask here!
User avatar
Moonbogg
Staff Sergeant
Staff Sergeant
Posts: 1551
Joined: Mon Oct 13, 2008 10:20 pm
Location: SoCal
Has thanked: 12 times
Been thanked: 3 times

Sun Feb 09, 2020 8:29 pm

Drill hole in golf ball and attach with self tapping screw through the dart tube. Think they will work good? I didn't mess with center of gravity or anything. Could be fairly cheap and easy to install. Might be awesome.
Attachments
golfball dart.jpg
User avatar
D_Hall
Staff Sergeant 4
Staff Sergeant 4
Posts: 1872
Joined: Thu Feb 07, 2008 7:37 pm
Location: SoCal
Been thanked: 3 times
Contact:

Donating Members

Mon Feb 10, 2020 1:40 am

It will probably work, yes. But I think it's also a lot tougher than required. Put it this way... I've had decent luck with nothing more than a 2" deck screw. Drill a small hole into the ball. Screw the deck screw in. Done. Doesn't look nearly as cool, but it works.
Simulation geek (GGDT / HGDT) and designer of Vera.
Post Reply