1-1/4 barrel sealing piston gb gun

[homedepotpro]

this was my first attempt at a piston in a tee, and it wasn't as hard as i thought it would be. the piston is 2'' dia. washers with an o-ring all on a 1/4'' thredded rod. My pilot valve is a 3/4'' sprinkler valve, recycled from an old sprinkler system, can you say "free-bie" At 80psi it will launch a gb 400 yards, in other words, it pwns sprinkler valves. it is 1-1/4'' port because it was nervous that if i went 1-1/2'' i wouldn't be able to get my piston to actuate. well here are some pics.





suggestion are welcome and wanted, im going to put barrel supports in soon.

[jackssmirkingrevenge]

Very good, looking forward to higher pressure testing and damage pics

[spud yeti]

Looks good. Thats some pretty impressive results too
Only suggestion: Perhaps paint it if you want to, but it still looks cool enough

[MrCrowley]

Looks great, Nice and simple, very clean., makes me want to go up to my garage and shoot my 2" barrel sealer

Why have a nice, clean, o-ringed piston when you can use a <A HREF="http://www.spudfiles.com/forums/how-to- ... >Deodorant can</a>