Where r u guys getting your 4" Pressure rated PVC fitti

[socoj2]

So home depot doesnt have jack. for SCH40 4" fittings.

Neither does Ace...

Maybe im looking at this wrong... Does it have to be sch40? if it isnt how do you determine if a fitting is for Pressure, most of the stuff at Home Depot is DWV...

I need a 4" to 2" reducer and 4" couplers

[e1337]

I get mine from a local pluming store that have pressure rated fittings up to 20". And pipe up to 24"!

-e1337

[ralphd]

I was at Lowes who had a better selection of fittings. They had a direct threaded reducer from 2" pipe to 1 1/2" male thread. I first went to Home Depot where I had to "adapt" a few fittings to get what I needed. I believe they were Lasko fittings.

[octane89]

He needs 4in fittings...so a 2" to 1 1/2" would be pretty useless.
No were near me carries fitting over 2" that are pressure rated. Best bet is mcmaster online.

[benstern]

Ace Hardware is where I get all my stuff.

[TurboSuper]

I get mine from a plumbing/heating supply store, check your phone directory.

[Maniac]

yea i get all my fittings from ace hardware and my pipe from lowes
Ace also has sch 80 fittings.

[daberno123]

I had the same problem of getting 4"-2" reducers. I got 4" couplings and 4"-2" bushings off McMcaster. They are pretty expensive for fittings (about $8 for a 4"-2" bushing)

Heres the part # for them
4880K231

[socoj2]

ahh sweet. I didnt see that page before.. Daberno your awesome..

[unisonmind]

i get my fittings from http://www.sprinkler.com for the most part or http://www.mcmaster.com but the fittings at sprinkler cost less ($10.60 for both fittings)

[ralphd]

Thanks, that's a good site. I already selected the fittings for my next launcher & I didn't leave the couch.

[SpudMonster]

I get mine from a plumbing/heating supply store, check your phone directory.

This. Between the stores in your area, you will have a very nice selection of eclectic fittings. Irrigation supply stores will have huge amounts of PVC pipe and fittings as well. I only use mcmaster if I have to have the parts right away or I can't find them anywhere nearby, as they are a lot pricier than normal. They do stock quality stuff though.

[daberno123]

They do stock quality stuff though

yeah i ordered some two inch elbows off McMaster and they just seem to be made of a better grade of pvc or something. Maybe its just my imagination or something

[bigbob12345]

I posted a topic similar to this a month ago and got some advice on where to find larger than 2in pipe. I now get it at a plumbing supplys store at a pluming supply store. Some of them can be quite expensive, I had to check a couple of them before I found one with fair prices.Just have a look in your phone book and check out a couple of them in there and you will fing what you are looking for.

[socoj2]

I had the same problem of getting 4"-2" reducers. I got 4" couplings and 4"-2" bushings off McMcaster. They are pretty expensive for fittings (about $8 for a 4"-2" bushing)

Heres the part # for them
4880K231

Grr shoulda looked closer

The one you posted is socket to threads... i wanted socket to socket.. LOL they just showed up and i was like GRRRR