Primer Bubbles???

[SpudBlaster15]

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Cras nec placerat erat. Vivamus dapibus egestas nunc, at eleifend neque. Suspendisse potenti. Sed dictum lacus eu nisl pretium vehicula. Ut faucibus hendrerit nisi. Integer ultricies orci eu ultrices malesuada. Fusce id mauris risus. Suspendisse finibus ligula et nisl rutrum efficitur. Vestibulum posuere erat pellentesque ornare venenatis. Integer commodo fermentum tortor in pharetra. Proin scelerisque consectetur posuere. Vestibulum molestie augue ac nibh feugiat scelerisque. Sed aliquet a nunc in mattis.

[spudy buddy]

OMG those cuts look soooo deap. if it was me i'd be screaming my head off.

[Ragnarok]

Well, if I ever make a Youtube spudgun show, then I'll put a "when spudguns go bad" section in it.

And those cuts aren't as bad as they look, there's just quite a few of them. I've made had deeper cuts in my arm myself, just not that many. Mind you, I'm not setting off gunpowder in PVC.

[spudy buddy]

well they look deep but your right there are just a lot of them but would seting off gunpouder in copper be safe?

[thespeedycicada]

Nope that seems more dangerous. pvc shards make the red water come out and copper shards will make you take the dirt nap.Just buy a real bp cannon if you must play with solid propellants.

[pizlo]

I'll bet you didn't sand all your contacts thoroughly?
And also I think you guys underestimate hotglue.

[spudy buddy]

no i'm not gona use solid propelants(against forum rules) cause i dont want that hapaning to me.

i like hot glu but my gun doesn't get it hot enough so it sucks for casting in tight spaces.

contacts? like joints?