Can I reverse Solvent welding?

A place for general potato gun questions and discussion.
Post Reply
User avatar
Counterstriker
Specialist 4
Specialist 4
Posts: 426
Joined: Tue May 29, 2007 2:06 pm

I made a cannon the other day and I used a really good shrader.. I only have the rubber ones now(no not the ones for bikes) and they can only go to 50 psi.. I was aiming for 100.. Is there any way I could reverse solvent welding instead of sawing it off...
Top
User avatar
bigbob12345
Staff Sergeant
Staff Sergeant
Posts: 1516
Joined: Sat Dec 01, 2007 9:13 am
Location: Mercer Island,Washington

No(message to short)
Top
User avatar
mopherman
Corporal 3
Corporal 3
Posts: 788
Joined: Sat Feb 03, 2007 8:20 pm
Been thanked: 1 time

Ypu can take the rubber ones to 100. Maybe a little epoxy reiforcement?
searching for a modern day savior from another place,inclined toward charity,everyone's begging for an answer,without regard to validity,the searching never ends,it goes on and on for eternity
-Bad religion
Top
User avatar
jrrdw
Moderator
Moderator
United States of America
Posts: 6572
Joined: Wed Nov 16, 2005 5:11 pm
Location: Maryland
Has thanked: 39 times
Been thanked: 22 times
Contact:
Contact jrrdw

Why not pull it out with pliers and use a thin piece of wire to feed a new through the hole.
Top
User avatar
base45
Private 3
Private 3
Posts: 55
Joined: Tue Feb 26, 2008 12:42 am
Location: Sacramento, CA

i use the rubber ones and i have got it up to 125 with no problem, but i did have quite a bit of epoxy to reinforce it.
Top
User avatar
Counterstriker
Specialist 4
Specialist 4
Posts: 426
Joined: Tue May 29, 2007 2:06 pm

Thanks anyway. I just got a dremel and cut it open. There goes my second cannon.
Top
User avatar
starman
Sergeant Major
Sergeant Major
United States of America
Posts: 3027
Joined: Wed Dec 12, 2007 12:45 am
Location: Simpsonville, SC

Dang man, why don't you just buy another schrader...unless I guess if your other cannon was truly worthless.
Top
User avatar
Counterstriker
Specialist 4
Specialist 4
Posts: 426
Joined: Tue May 29, 2007 2:06 pm

starman wrote:Dang man, why don't you just buy another schrader...unless I guess if your other cannon was truly worthless.
It was pretty lame. Just a gay ball valve.
Top
Post Reply

Create an account or sign in to join the discussion

You need to be a member in order to post a reply

Create an account

Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute

Register

Sign in

  • Similar Topics
    Replies
    Views
    Last post

Return to “General Cannon Discussion”