just wanna build a small simple blaster, need ignition help

[F.E.A.R._Sniper]

ok so ever sinced i found out that paintball pnuematic tubing will fit on the tip of a lighter i have wanted to build a small launcher using lighters as a combination fuel injector/ fuel shut off valve/ and fuel canister. I was thinking about taking some 3/4" schedule 80 pvc pipe and drilling a bunch of holes for about 6-8 inches down the length of the pipe. after that i was gonna place the end of the pipe with all the holes down inside a soda bottle. there would be barbs placed on the bottle and all you would have to do is press the button on the lighter to fill the chamber with gas.

I am having trouble in coming up with an idea to ignite this. do any of you guys have an idea of what i can do for ignition.

[hi]

use a paper clip and a bbq ignitor. not very complicated. im not going to tell you what to do with the bbq ignitor and the paper clip, thats for you to figure out.

[F.E.A.R._Sniper]

well my major problem is that the bottle kinda flimsy, i know how to make a spark gap

[jimmy101]

Build the spark gap onto the sch80 piece of pipe?

You could just gently heat a couple pins and push them through the soda bottle's wall. Then, a big-ol glob-a epoxy^TM (liquid nails, hot melt glue, caulk ....) on the outside of the bottle to hold the pins in place.

[JDP12]

yea i say waht jimmy101 says... but it would be messy

[TwitchTheAussie]

Just hurry up stick some nails in glue em up nand light that sucker up real nice. You got what you needed.

[F.E.A.R._Sniper]

thanks jimmy, i think i will go with building the spark gap onto the pvc pipe