10mm Hybrid cannon

[SpudFarm]

you can't thing out how wordles i am that those solder joints held up :S

well any 10x that gets fired in chambers like this makes me want to fire my big hybrid even more

[Gunner]

Haha my solder joints beat you anyway, the gun have very much recoil at 10x and the 10x make a very big hole in 6mm steel plate

[SpudFarm]

you took the magical 1/4" mark!

congratts on a very good hybrid

[Gunner]

Thank you very much!
(PS.I am too impressed that the cannon can hold 10x)

[SpudFarm]

well it is copper and the soldering LOOKED bad but you might just spilled a little

i think that pipe has a burst pressure of around 2200psi - just so you know

[Gunner]

I can take a new shot and pic from 6mm plate if you want

[SpudFarm]

if i want? are you crazy?

of course i want!

[Gunner]

Haha, I knew it...I will do it tommorow.

[Gunner]

Here is damage pic, 6mm iron plate, the hole looks much deeper in real:


And schematic of my gun:


Hope you understand

[SpudFarm]

that is so awesome!
your burst disk design gives me some ideas.. is it possible for you to get on msn and help me a little there? seems like you have your top floor in right gear

[Gunner]

Of course I can...

[sniper hero]

coool
this gun is incredible I might try some small scale hybrid experiments:P

[ALIHISGREAT]

I like the intergrated burst disc holder, instead of having a sperate union, i was thinking of using cam-locks on mine but maybe this is a better route to go down

[Gunner]

Thanks...I think that this is much easier because you just have to weld a big nut to your chamber and then just get a big bolt and weld your barrel to it

[Ceppu]

Ei paha. Pitänee siirtyä hybrideihin jossain välissä.

Clean and compact build. And impressive performance. I like it!