Micro BBMG musings

[jackssmirkingrevenge]

Running at 500 psi it didn't leak, haven't tried it at 800. I don't know how freezing issues with CO₂ might affect sealing.

Taking the valve apart, there is a plastic tube holding the rubber seal the stem presses against in place, this might be prone to distortion if subjected to excess pressure and might need to be replaced with a stronger metal tube.

[JDP12]

yea mine is metal... but it didn't seal at 800..

I tried putting in a spacer to increase spring tension... But then the spacer was too long, couldn't even operate the valve...

And now I can't get the spacer out its jammed in there so tight LOL.

I'll take a picture of internals and slap it up here in a bit.


Do you think if i turned the pipe 90 degrees so it was horizontal it would still be able to operate successfully? I don't see why not..

[jackssmirkingrevenge]

It might be worth looking into pressure washer handles or ball valves at these pressures.

Do you think if i turned the pipe 90 degrees so it was horizontal it would still be able to operate successfully? I don't see why not..

Which pipe?

edit: prototype can be seen in action here