Simple Question I Just Haven't Been Able To Get An Answer To

[Foxx]

Hey guys, I know this is a really basic/probably stupid question, but can someone here explain to me exactly what is a co-axial and how it works/how to make one? (Yes, I have searched, and no, I didn't find a satisfactory answer)

Thanks

FOXX

[Gippeto]

http://www.spudfiles.com/forums/piston- ... ter,0.html

The third animation is a co-axial.

What "sets it apart" is that the barrel runs through the entire chamber.

[Pilgor]

Don't use a bell reducer

[Technician1002]

The actual definition of coaxial is two cylinders on the same axis. The chamber is outside the barrel. The most common configuration is a piston in the breech with the barrel inside the chamber to the piston at the breech. The term comes from the electronics industry where a cable has one conductor inside the other one.

http://en.wikipedia.org/wiki/Coaxial_cable

A coaxial cable has an outer conductor on the same axis as the center conductor.

[Carlman]

Why do all the words in the title of this thread have a capital letter?

Looks like it needs an acronym... SQIJHBATGAAT.......

[THUNDERLORD]

Why do all the words in the title of this thread have a capital letter?

Looks like it needs an acronym... SQIJHBATGAAT.......

Actually there was a thread about a year ago on making better posts, and it instructed to use cap.s...It was a good usefull post, (Link? can't find it now???), About writing cannon specs, getting more views etc.
I always capitalize each word in a post since I read it. 8)

BTW, for pneumatics aren't co-axial the most efficient(???)
I just like them because of the "Bullpup" configuration I'm fond of.
Also been thinking about them because all the dang brass "T"'s I find are cast. Course I did see smaller diameter cast fittings on a helium tank recently.
Besides all the local brass nipple pipe only goes to 3/4" so my chamber would be too small. Guess I'll stick with my cast brass "T"...
EDIT:Found it I think Great posting info too.
I thought it was a sticky. Should be added to the "rules" IMO.
Where the heck is MrC.??? If I don't find out soon I will probably flip out!!!
PM me someone....
EDIT2: No that's not the exact thread (??? where???)...